Large selection of design solutions
Thanks to our extensive experience and highly qualified technologists, we are able to produce glossy fences. This became possible thanks to technology developed over the years and the use of only high-quality raw materials:
The production standards we have developed are applied daily and without deviation:
High quality
For the production of Euro fences, we use only grade 500 cement. This cement allows us to produce products that meet high requirements for water resistance, frost resistance and durability.
The slabs are reinforced with an all-welded metal mesh, and the posts with an all-welded ladder made of 6 mm BP rod. This allows you to increase the strength of the finished product.
Reliability
We use fine crushed stone (the so-called “cub”).
We add to concrete only the best additives that have been proven over the years, increasing the quality of the concrete and the frost resistance of the finished products.
We provide high-quality installation of fences, which does not cause subsidence of the posts and, as a result, cracking of the slabs.
Frequently asked questions
✔ What are fence sections?
These are frames with stretched welded mesh or profiled pipes with a cross-section of 60 mm in the form of diamonds, rectangles, squares with different cell sizes. Supplied with accessories, fasteners, posts.
✔ Do I need to leave a gap between the ground during installation?
Fences made of corrugated sheets are subject to windage. Thanks to the lower gap of 10-15 cm, the sheets are not blown away by hurricane winds.
✔ What is the best way to build a fence?
You can enclose a yard or site with corrugated sheets with a zinc-aluminum/pural coating, galvanized euro picket fence, a louvered fence, sections made of welded rods.
Perforated fences
Fences are made of posts, horizontal profiled pipes of any section. The spans are filled with steel perforated sheets with powder coating. The holes are punched on coordinate punching machines, ensuring the accuracy of the dimensions. Translucency depends on the frequency of perforation and location: along the edges, the bottom or the entire surface. Hole shapes:
Rv — round offset with a diameter of 1/2 mm with a pitch of 20/26 mm;
Rq — spherical linear 8 mm with a distance of 9-20 mm;
Qq — square 10x10 mm with a pitch of 8-14 mm;
Lv — slit-shaped, staggered at a distance of 1-5x25 mm.
Perforations can also be figured and made in the form of ornaments. Painting according to the RAL catalog allows you to choose a shade to match the facade.
Call us, our specialists are ready to answer any of your questions. If for any reason you cannot call or did not get through, write to us and we will call you back!
+1710-000-0000
+1710-000-0000
USA, Albuquerque